Band Menu; Setting Preset Stations - Cadillac Escalade Manual

To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear
two beeps and PSCAN will appear on the display, along
with the highlighted preset. The radio will go to one of
the preset stations, play for a few seconds, then go on to
the next preset station. Press either SEEK arrow
again to stop scanning presets.
The radio will only seek and scan stations with a strong
signal that are in the selected band.

Setting Preset Stations

Up to 30 stations, six AM, six FM1, six FM2, six XM1,
and six XM2, if equipped, can be programmed using
the six screen buttons on the bottom of each band
menu. To set preset stations, do the following:
1. Turn the audio system on.
2. Press the BAND hard key to select AM, FM1, FM2,
XM1, or XM2, if equipped.
3. Tune to the desired station using the SEEK hard
key or the tuning knob.
4. Press and hold one of the six preset screen buttons
until you hear a beep. Whenever that preset screen
button is pressed, the station that was set will return.
5. Repeat the steps for each preset and source.

Band Menu

If the radio is on while the navigation system is not in use,
this band menu will display the current audio information,
as well as list the presets for the current band.
FM1 Source shown, Other Sources similar
If the radio is on while the navigation system is in use,
a smaller band menu will appear, located on the left
side of the map screen.
3-3