Sony PMC-MD55 Service Manual page 126

5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
(1) Set the disc in the unit. (Whichever recordable discs or discs for playback only are available)
(2) Turn the JOG dial and display "CPLAY MODE".
[YES, ENTER]
(3) Press the
(4) When access completes, the display changes to "C1 =
Note: The numbers " " displayed show you error rates and ADER.
2. Changing the parts to be played back
[YES, ENTER]
(1) Press the
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
When pressed another time, the parts to be played back can be moved.
(2) When access completes, the display changes to "C1 =
Note: The numbers " " displayed show you error rates and ADER.
3. Ending the continuous playback mode
[NO, CANCEL]
(1) Press the
[MD EJECT
(2) Press the
Note: The playback start addresses for IN, MID, and OUT are as follows.
IN : 40h cluster
MID : 300h cluster
OUT : 700h cluster
5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check)
1. Entering the continuous recording mode
(1) Set a recordable disc in the unit.
(2) Turn the JOG dial and display "CREC MODE".
[YES, ENTER]
(3) Press the
(4) When access completes, the display changes to "CREC (
Note: The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
[YES, ENTER]
(1) When the
"CREC MID" n "CREC OUT" n "CREC IN"
When pressed another time, the parts to be recorded can be changed. "
(2) When access completes, the display changes to "CREC (
Note: The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
[NO, CANCEL]
(1) Press the
[MD EJECT ]
(2) Press the
Z
Note 1: The recording start addresses for IN, MID, and OUT are as follows.
IN : 40h cluster
MID : 300h cluster
OUT : 700h cluster
[NO, CANCEL]
Note 2: The
Note 3: Do not perform continuous recording for long periods of time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vibration.
5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If the unit entered this mode accidentally, press the
button to change the display to "CPLAY MID".
button during continuous playback to change the display as below.
button. The display will change to "CPLAY MODE".
]
Z button and take out the disc.
button to change the display to "CREC MID".
button is pressed during continuous recording, the display changes as below.
button. The display changes to "CREC MODE" and "
button and take out the disc.
button can be used to stop recording anytime.
AD = ".
AD = ".
[REC]
)" and " " lights up.
[REC]
" goes off.
[REC]
)" and " " lights up.
[REC]
[NO, CANCEL]
– 17 –
" goes off.
button immediately to release it.