Cannot Print Over A Network - Canon iPF785 Series Basic Manual

Cannot connect the printer to the network

Cannot print over a network

Cannot print over a network
Cannot connect the printer to the network ...................................................................................................... 104
Cannot print over a TCP/IP network .................................................................................................................... 104
Cannot print over a Bonjour network .................................................................................................................. 104
Cannot connect the printer to the network Cannot connect the printer to the network
Cause
The Ethernet cable
is not connected cor-
rectly to the printer's
Ethernet port.
Cannot print over a TCP/IP network
Cannot print over a TCP/IP network
Cause
The printer's IP address is not
configured correctly.
The printer's TCP/IP network set-
tings are not configured correctly.
The computer you are trying to
print from is not configured cor-
rectly.
Cannot print over a Bonjour network
Cannot print over a Bonjour network
Cause
The computer you are trying to
print from is not configured cor-
rectly.
The computer and printer are
not on the same network.
104
1.
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the print-
er on. For instructions on connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The bottom indicator is green if the printer is connected via 1000Base-T, while the top indicator is orange
if connected via 100Base-TX and the top indicator is green if connected via 10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the hub is on.
•
Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
•
Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission rate automati-
cally (in auto negotiation mode), sometimes the hub settings cannot be detected. In this case, config-
ure the connection method manually, specifying the communication mode in use.
(See "Configuring the Communication Mode Manually.")
Make sure the printer's IP address is configured correctly.
(See "Configuring the IP Address Using imagePROGRAF Device Setup Utility.")
(See "Configuring the IP Address Using the Printer Control Panel.")
Make sure the printer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.")
Make sure the computer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer Driver Destination (Windows).")
(See "Configuring the Destination in TCP/IP Networks (Macintosh).")
Make sure the computer is configured correctly.
(See "Configuring the Destination for Bonjour Network (Macintosh).")
Due to the nature of Bonjour, you cannot print if the printer is on another network behind a router.
Make sure the computer and printer are on the same network. For information about network set-
tings, ask your network administrator.
Corrective Action
User's Guide
➔
Corrective Action
➔
Corrective Action
iPF785 Series
User's Guide
➔
User's Guide
➔
User's Guide
➔
User's Guide
User's Guide
➔
User's Guide
➔
Basic Guide