Mts Broadcast/Tv Stereo System; Audio Mode For Tv Viewing - Panasonic PV-DF2003-K Operating Instructions Manual

MTS Broadcast/TV Stereo System

Equipped with -TV Noise
Reduction for true MTS
reproduction. -TV Noise
Reduction is required for good
stereo separation and audio fi delity.
is a registered trademark,
and is licensed by
Technology Licensing.
AUDIO
DISPLAY

Audio Mode for TV Viewing

Press AUDIO to select the desired audio mode as described above.
(Arrow shows selection.)
• Each press of AUDIO will change the audio mode as shown below.
• "SAP" is selected with fi rst press of AUDIO.
< Example >
Press AUDIO
STEREO
SAP
MONO
Press AUDIO
Receivable Broadcast Types
The following are possible audio broadcast types and
on-screen displays. The signal being received is indicated with
an " " mark while the selected audio mode is indicated with
an arrow. To change the audio mode for these broadcasts, see
the "Audio Mode for TV Viewing" section below.
Press DISPLAY to display the broadcast signal being
received.
MTS Stereo and SAP broadcast
1 2 : 0 0AM CH08
Multi-channel Television Sound Stereo
SP
STEREO
SAP
(main language) and Secondary Audio
MONO
Program (sub language) broadcasts
are being received simultaneously.
Select the STEREO or SAP audio
mode.
MTS Stereo broadcast
CH08
1 2 : 0 0AM
Multi-channel Television Sound Stereo
SP
STEREO
SAP
broadcast. Select STEREO audio
MONO
mode.
• If stereo broadcast is weak and the
display fl ickers, select MONO audio mode
for possible improvement.
SAP broadcast
CH08
1 2 : 0 0AM
Secondary Audio Program (sub
SP
STEREO
SAP
language). Select SAP audio mode for
MONO
the sub language.
MONO broadcast
CH08
1 2 : 0 0AM
Normal monaural sound broadcast.
SP
STEREO
SAP
MONO
STEREO
SAP
MONO
Press AUDIO
STEREO
SAP
MONO
25