Draining Water From Fuel Filter - Mitsubishi 2010 Fuso FE Owner's Manual

5. Clean the inside of case
clean cloth.
6. Replace the element with a new one if the check
reveals a defective filter element or when the
recommended replacement interval expires.
Use a genuine filter element for replacement.
7. Install the element by reversing the order of
removal. Be sure to align match marks
case and cover.
CAUTION
Z09266
Install the element correctly.
If the packing is broken or the wing nut is loose,
the engine will suck in dust and premature pis-
ton and cylinder liner wear could result.

Draining water from fuel filter

If the
the fuel filter in an amount exceeding the limit.
Drain the water as follows:
WARNING
•
Z12062
Fuel is highly flammable and should be
kept away from hot objects and open
flames owing to the risk of fire or explo-
sion. Wipe up any spilt fuel.
•
Keep cigarettes and other sources of heat
away from the vehicle while draining water
from the fuel filter. They are dangerous
because they could set fire to the fuel.
•
Be careful not to injure yourself on the
edges of nearby components while drain-
ing water from the fuel filter.
1. Prepare a receiver for water.
2. Disconnect the connector on the sensor
turn the sensor in the direction of the arrow
loosen it; the water will flow from the pipe at the
end of the sensor.
Operating priming pump
draining.
3. When fuel begins to flow out, close the drain
port by tightening the plug in the direction of the
arrow
Connect the connector.
warning lamp lights up, there is water in
.
12-47
and cover with a
on the
, then
to
helps quicken the