Mitsubishi 2010 Fuso FE Owner's Manual page 192

2. Check that the oil surface
ing of the inspection plug hole
finger straightly into it. If insufficient, add the oil
from the inspection plug hole up to the opening.
CAUTION
The added oil should be of the same grade and
viscosity as the oil originally placed in the dif-
ferential gears.
Z18456
3. Install the inspection plug.
Tightening
torque
5.2 Replacement
1. Remove inspection plug
let the oil flow out.
WARNING
Do not replace the oil immediately after driv-
ing, as you could be scalded by extremely
hot oil. Give the oil time to cool before drain-
ing it.
NOTE:
Oil removal is quicker if performed not so long after
the vehicle has been stopped and while the oil is
still warm.
2. Install the drain plug. The drain plug on the front
axle is fitted with a magnet. Wipe off any metal
particles sticking to the magnet before installing
the drain plug.
Tightening
torque
3. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
4. Install the inspection plug.
Tightening
torque
reaches the open-
by putting your
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
and drain plug
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
98 to 115 N·m (72 to 87 ft.lbs.,
10 to 12 kgf·m)
12-35
to