Behringer Europower PMP860M User Manual page 9

EUROPOWER PMP860M/PMP880S/PMP1280S
Both the PMP880S/PMP1280S and the PMP860M can be set-up for
dual mono operations. The POWER AMP switch
to its lower (PMP860M) or center position (PMP880S/PMP1280S).
The two loudspeaker outputs provide the main and monitor signals
independently of each other and to two loudspeakers each, which
are wired in parallel.
Fig. 5.2: EUROPOWER as a dual mono amplifier (example)
This illustration shows just one example of how the channels of
your power mixer can be used, including the connection of mono
and stereo sources, and the tape ins and outs recording the mix
signal or playing back external signals.
Fig. 5.3: Standard set-up (example)
One example of how to use your power mixer with a subwoofer
must be set in bridged mono mode. The illustration shows the PMP1280S
with a subwoofer connected to OUTPUT B that will receive the
full (bridged) output power. A separate stereo power amp
(BEHRINGER EUROPOWER EP1500) for the stereo main P.A.
signal is connected to the PRE AMP MAIN outputs. The PRE AMP
MONITOR output is wired to active speakers on the stage. This
application can also be realized with the PMP860M, except for
the main P.A. signal, which would be mono.
Fig. 5.4: EUROPOWER in bridged mono mode
5. WIRING EXAMPLES 9