Operation Using Remote Controller - Prem-I-Air EH0530 Instruction Manual

H. OPERATION USING REMOTE CONTROLLER (Type V5)
1. Remove the cover from the back of the remote
control.
2. Insert two AAA dry-cell batteries (batteries
included).
After inserting the batteries, the display of
the remote control will flash COOL and
HEAT orderly : to set the remote control of
your unit, you can press the MODE button
when the remote is flashing HEAT on the
display.
3. Insert the power plug into an outlet.
4. Always point the remote control signal
transmitter toward the unit when operating.
5. Make sure that the signal path is not obstructed.
6. The maximum distance at which signals can be received is 8M.
7. Remove the batteries if the unit is not going to be used for an extended
period of time.
A CHANGE IN THE FUNCTION IS USUALLY INDICATED BY A BEEP.
8. Do not abuse the remote control
9. Do not place the remote control in a location that is exposed to direct
sunlight or next to a heating unit or other heat source.
10. Do not use rechargeable batteries because they differ from standard dry
cell batteries in shape, dimension and performance.
11. Be sure to replace the batteries with two new batteries of the same type.
IMPORTANT: At the end of their life dispose of the batteries according to Local
Authority regulations. Do not dispose of batteries with your normal household
rubbish.
Remote control real time clock instructions
1. Press the CLOCK button.
2. Press the HR (hour) button and MIN (minute) button and adjust the correct
time.
3. Press the CLOCK button again.
4. The display will show the correct time.
Page 18