Chapter 5: Setting Up The Wireless-G Ethernet Bridge; Figure 5-1: Welcome; Figure 5-2: Connection - Linksys WET54GS5 User Manual

Wireless-G Ethernet Bridge with 5-Port Switch

Chapter 5: Setting Up the Wireless-G Ethernet Bridge

Now that you've connected the Wireless-G Ethernet Bridge to your wired network, you are ready to set it up. The
Setup Wizard will guide you through all the necessary steps.
1. Insert the Setup CD-ROM into your PC's CD-ROM drive. The Setup Utility should run automatically, and the
screen in Figure 5-1 should appear. If it does not, click the Start button and choose Run. In the field that
appears, enter D:\setup.exe (if "D" is the letter of your CD-ROM drive).
• Setup - Click the Setup button to proceed with the Setup Wizard.
• User Guide - Click the User Guide button to open the PDF file of this User Guide.
• LINKSYS Web - Click the LINKSYS Web button to access the Linksys website using an active Internet
connection.
• Exit - Click the Exit button to exit the Setup Wizard.
2. Click the Setup button to begin the setup process.
3. Make sure the Bridge is correctly connected to your wired network (see Figure 5-2). Then click the Next
button.
Chapter 5: Setting Up the Wireless-G Ethernet Bridge
Note: While the Wireless-G Ethernet Bridge has been
designed to work correctly right out of the box, setting
it up on a wireless computer will require you to use the
Linksys default settings (SSID: linksys and mode:
infrastructure). These settings can then be changed
through the Bridge's Setup Wizard or Web-based Utility.

Figure 5-1: Welcome

Figure 5-2: Connection

12