Remote Control - Dynex DX-16E220NA16 User Manual

Dynex 16" LED TV
Problem Solution
The picture has a
• A few bright or dark spots on an
few bright or dark
spots.
Good picture, but
• Increase the volume.
no sound.
• Unplug the headphones.
• Make sure that the sound is not
• Make sure that the correct
• Make sure that the audio cables
• Make sure that the antenna or
• If you are using an antenna, the
• The audio cable(s) you are using
Poor picture.
• Make sure that the room is not
• If an S-VHS camera or a
Good sound but
• Adjust the contrast, color, and
poor color.
Audio noise.
• Other devices (for example,
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
LCD screen is normal. It does
not affect the operation of this
TV.
muted.
audio mode is selected.
are connected correctly and
securely to the back of your TV.
cable TV is connected correctly
and securely. See "Connecting a
cable or satellite box" on
page 15 or "Connecting an
antenna or cable TV (no box)"
on page 19.
digital channel signal may be
low. To check the digital
channel signal strength, see
"Checking the digital signal
strength" on page 56.
may be bad. Try a new set.
too bright. Light reflecting off
the screen can make the picture
difficult to see.
camcorder is connected while
another connected device is
turned on, the picture may be
poor. Turn off one or more
devices.
brightness settings. See
"Adjusting the TV picture" on
page 42.
surround sound receiver,
external speakers, fans, or hair
dryers) may be interfering with
your TV. Try turning off one
device at a time to determine
which device is causing
interference. After you have
determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
"Adjusting sound settings" on
page 44.
are connected correctly and
securely to the back of your TV.
www.dynexproducts.com
Problem Solution
After images
• Do not display a still image,
appear.

Remote control

Problem Solution
Remote control
• Make sure that the AC power
does not work.
• Make sure that there are no
• Point the remote control
• Make sure that the batteries are
• Replace dead batteries with
Trouble
• See instructions and a table of
programming
your existing
universal remote
control.
• Codes are subject to change.
• Replace dead batteries with
• Refer to the User Guide that
DX-16E220NA16
such as a logo, game, or
computer image, for an
extended period of time. This
can cause a permanent
after-image to be burned into
the screen. This type of damage
is not covered by your warranty.
adapter is correctly connected
to your TV and a working power
outlet.
obstructions between the
remote control and the remote
control sensor on the front of
the TV.
directly at the remote control
sensor on your TV. For the
location of the remote control
sensor, see "Front" on page 10.
installed correctly. See
"Installing remote control
batteries" on page 33.
new batteries. See "Installing
remote control batteries" on
page 33.
common codes in
"Programming universal remote
controls" on page 62.
For up-to-date codes, go to
www.dynexproducts.com/remotecodes
new batteries. See the User
Guide that accompanied the
universal remote control.
accompanied your universal
remote control and contact the
manufacturer if problems
persist.
59