ZyXEL Communications MES3500 Series User Manual page 317

The following table describes the labels in this screen.
Table 149 Management > Configure Clone
LABEL DESCRIPTION
Source/ Enter the source port under the Source label. This port's attributes are copied.
Destination
Enter the destination port or ports under the Destination label. These are the ports which
Port are going to have the same attributes as the source port. You can enter individual ports
separated by a comma or a range of ports by using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to
the destination port(s).
Advanced Select which port settings (you configured in the Advanced Application menus) should be
Application copied to the destination ports.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 44 Configure Clone
MES3500/MGS3520 Series User's Guide
317