Viewing And Editing Classifier Configuration - ZyXEL Communications MES3500 Series User Manual

Table 48 Advanced Application > Classifier (continued)
LABEL
IP
Address/
Address
Prefix
Socket
Number
Add
Cancel
Clear

20.3 Viewing and Editing Classifier Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the bottom
of the Classifier screen. To change the settings of a rule, click a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over a lower
layer rule.
Figure 88 Advanced Application > Classifier: Summary Table
The following table describes the labels in this screen.
Table 49 Classifier: Summary Table
LABEL
Rule
Usage
Index
Active
Name
Rule
Delete
Cancel
Chapter 20 Classifier
DESCRIPTION
Enter a destination IP address in dotted decimal notation.
Specify the address prefix by entering the number of ones in the subnet mask.
Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket
numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option
and enter a TCP/UDP protocol port number.
Click Add to insert the entry in the summary table below and save your changes to the Switch's
run-time memory. The Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to set the above fields back to the factory defaults.
DESCRIPTION
This field displays how many rules have been configured on the Switch.
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays Yes when the rule is activated and No when it is deactivated.
This field displays the descriptive name for this rule. This is for identification purposes only.
This field displays a summary of the classifier rule's settings.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
MES3500/MGS3520 Series User's Guide
157