The Administration Tab - Factory Defaults; The Administration Tab - Firmware Upgrade; Figure 5-28: Administration Tab - Factory Defaults; Figure 5-29: Administration Tab - Firmware Upgrade - Linksys RT31P2 Installation And Troubleshooting Manual

The Administration Tab - Factory Defaults

The Factory Defaults screen is protected by a password available only from your Internet phone service
provider. Contact your provider for more information.
This screen is used to reset all the factory defaults. If you just want to reset the factory defaults for the Router,
on the back of the Router, press the Reset Button for five seconds.

The Administration Tab - Firmware Upgrade

Upgrading the Router's firmware requires a password available only from your Internet phone service provider.
Contact your provider for more information.
Chapter 5: Configuring the Router
The Administration Tab - Factory Defaults
Broadband Router with 2 Phone Ports
Figure 5-28: Administration Tab -
Factory Defaults
Figure 5-29: Administration Tab -
Firmware Upgrade
firmware: the programming code that
runs a networking device
upgrade: to replace existing software or
firmware with a newer version
43