Administration > Factory Defaults; Administration > Firmware Upgrade - Linksys RangePlus WRT100 User Manual

Chapter3
Diagnostics
Ping Test
The Ping test checks the status of a connection.
IP or URL Address
Enter the address of the PC whose
connection you wish to test.
Packet Sze
Enter the packet size you want to use. The
default is 32 bytes.
Tmes to Png Enter many times you wish to test it.
Start to Png To run the test, click this button. The Ping
Test screen will show if the test was successful. Click Close
to return to the Diagnostics screen.
Diagnostics > Ping
Traceroute Test
The Traceroute test tests the performance of a
connection.
IP or URL Address
Enter the address of the PC whose
connection you wish to test.
Start to Traceroute To run the test, click this button. The
Traceroute Test screen will show if the test was successful.
Click Close to return to the Diagnostics screen.
Diagnostics > Traceroute
RangePlus Wreless Router
Advanced Configuration
Administration > Factory Defaults
The Administration > Factory Defaults screen allows you
to restore the Router's configuration to its factory default
settings.
Administration > Factory Defaults
NOTE: Do not restore the factory defaults unless
you are having difficulties with the Router and
have exhausted all other troubleshooting
measures. Once the Router is reset, you will have
to re-enter all of your configuration settings.
Factory Defaults
Restore Factory Defaults
to the default values, click this button and then follow the
on-screen instructions. Any settings you have saved will
be lost when the default settings are restored.
Administration > Firmware Upgrade
The Firmware Upgrade screen allows you to upgrade the
Router's firmware. Do not upgrade the firmware unless
you are experiencing problems with the Router or the new
firmware has a feature you want to use.
Administration > Firmware Upgrade
To reset the Router's settings
22