How To Use - Remington HC70 User Manual

HOW TO USE

Before starting the cut
To attach a comb
To remove the comb
Comb Attachments Hair Lengths
STEP 1 – Nape of the neck – DIAGRAM 1
STEP 2 – Back of the head – DIAGRAM 2
STEP 3 – Side of the head – DIAGRAM 3
2
080681_HC70_UK.indd 2
ENGLISH
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
Hold the comb with its teeth upward
Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
Each comb attachment is marked accordingly on its outside middle surface (3mm, 7mm,
9mm, 12mm.
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start with the
maximum comb attachment
Use 3mm or 6mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
With the 12mm guide comb attached, cut the hair at the back of the head.
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm or 12mm guide comb and continue to cut to the top of the head.
10.09.2008 20:26:07 Uhr