Using Laundry Product Dispensers; Select Cycle - Whirlpool WFW87HEDW Use & Care Manual

USING LAUNDRY PRODUCT DISPENSERS

NOTE: Do not add single-dose laundry packets, Oxi-type
boosters, color-safe bleach, or fabric softener crystals to
dispensers. They will not dispense correctly.
4.
Add HE detergent
Liquid
HE detergent
Adjust the selector, based on type of HE detergent used
(either liquid or powdered). See "Using the Dispenser
Drawer" instructions on how to use the dispenser.
5.
Add liquid fabric softener to dispenser
(if desired)
Pour a measured amount of liquid fabric softener into liquid
fabric softener compartment. Always follow manufacturer's
directions for correct amount of fabric softener based on your
load size.
Fabric softener is always dispensed in the last rinse, even if
Extra Rinse is selected.
IMPORTANT: Do not overfill, dilute, or use more than ¼ cup
(60 mL) of fabric softener. Do not fill past the MAX line.
Overfilling dispenser will cause fabric softener to immediately
dispense into washer.
n Do not spill or drip any fabric softener onto the clothes.
n Do not use liquid fabric softener dispenser balls in this
washer. They will not dispense correctly.
6.
Add liquid chlorine bleach to dispenser
(if desired)
Add liquid chlorine bleach to the bleach compartment.
Do not overfill, dilute, or use more than
Do not use color-safe bleach or Oxi in the same cycle with
liquid chlorine bleach.
Always measure liquid chlorine bleach. Use a measuring cup
n
with a pour spout; do not guess.
Do not fill beyond the "MAX" level. Overfilling could cause
n
garment damage.
Powdered
HE detergent
⁄ cup (165 mL).
2
3
7.
Touch POWER to turn on washer
(optional)
Slowly close the dispenser drawer. Make sure the drawer is
closed completely, then touch POWER to turn on the washer
or go to Step 8.
8.

Select CYCLE*

Appearance may vary.
Turn cycle knob to select your wash cycle. See "Cycle Guide"
for details on cycle features.
9.
Adjust settings, if desired*
Appearance may vary.
The display will show the default settings for the selected
cycle. To adjust a setting, touch its name – Wash Temp, Spin,
Soil, or Presoak. Adjusting settings will change the Estimated
Time Remaining. Tightly packing the load, unbalanced loads,
or excessive suds may also cause the washer to increase the
cycle time.
* Not all options and settings are available with all cycles.
See "Cycle Guide" for available options and settings.
11