DeWalt DCT414 Instruction Manual page 13

Installing and Removing the Battery Pack
(Fig. 4)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (C) into the tool handle, align the battery with
the rails inside the tool's handle and slide it firmly into the handle until
you hear the lock snap into place.
FIG. 4
To remove the battery pack from the tool, press the release button (B)
and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Select Operating Mode
Read the following steps before operating the IR thermometer.
CHOOSE UNITS OF MEASUREMENT
Turn the unit on by engaging the trigger. Once the screen comes on
push the C/F button until the units of measurement is on the correct
setting for the application.
CHOOSE EMISSIVITY
Turn the unit on by engaging the trigger, once the screen comes on
push the EMS button for emissivity adjustment. When then EMS is
flashing on the screen, use the up or down arrow buttons to choose
the emissivity. Please refer to the chart in order to choose the correct
emissivity. Remember, emissivity is adjustable by 0.01.
B
C
CHOOSE ALARM SETTINGS AND HIGH/LOW
TEMPERATURES
1. Engage the trigger to turn the unit.
2. Push the ALM button.
3. When the ALM is flashing on the screen use the up and down
4. Push the ALM button again to confirm selection.
11
NOMINAL EMISSIVITY TABLE
MATERIAL VALUE MATERIAL
Default**** 0.95 Lead*
Aluminum* 0.30 Oil
Asbestos 0.95 Paint
Asphalt 0.95 Plastic**
Brass* 0.50 Rubber
Ceramic 0.95 Sand
Concrete 0.95 Steel*
Copper* 0.60 Water
Glass (plate) 0.85 Wood***
Iron* 0.70
* Oxidized *** Natural
** Opaque, over 20 mils **** Factory Setting
arrows to select the alarm type.
Alarm 1 – temperature has reached the set limit, indicated by
the red/blue LED (M)
Alarm 2 – temperature has reached the set limit, indicated by
a beeper sound
Alarm 3 – temperature has reached the set limit, indicated by
both the LED and the beeper
VALUE
0.50
0.94
0.93
0.95
0.95
0.90
0.80
0.93
0.94