English
Fitting the Auger
N
Shut off the engine and engage the
auger brake – see "Auger Brake".
N
Put the machine on the ground with
the drilling spindle facing up.
N
Pull the retaining pin (1) out of the
auger's shank.
N
Push the auger (2) onto the drilling
spindle so that the holes (3) line up.
N
Push the retaining pin into the hole.
N
Spring clip on the retaining pin must
fit snugly around the auger's shank.
10
Starting / Stopping the
Engine
Engaging the Auger Brake
N
Move the activating lever to
position A .
Starting
N
Press down the trigger interlock (1),
then squeeze the throttle trigger (2)
N
and hold them in that position.
N
Move the slide control (3) to START
and hold it there.
N
Now release the throttle trigger,
slide control and trigger interlock in
that order. This is the starting
throttle position.
BT 121