Approved Multiengines; Approved Combinations Of Cutting Attachment And Deflector; Fitting, Removing The Multitool - Stihl FS-MM Instruction Manual

4 Approved MultiEngines

If one of the wear limit marks on the PolyCut
mowing head is worn through (arrow): Do not
continue using the mowing head. Install a new
one. There is otherwise a risk of injury from
thrown parts of the head.
It is important to follow the maintenance instruc‐
tions for the PolyCut mowing head.
The PolyCut can also be equipped with mowing
line in place of the polymer blades.
The mowing head comes with instruction leaflets.
Equip the mowing head with polymers blades or
nylon line as described in the instruction leaflets.
5

Approved Combinations of Cutting Attachment and Deflector

Cutting attachment
1
4
5.1 Permissible combinations
Choose the correct combination from the table
depending on the cutting tool!
WARNING
For safety reasons, no other combinations are
permitted – risk of accidents!
Only mowing heads (1, 2, 3, 4, 5, 6) may be
used on the FS-MM MultiTool.
5.2 Cutting attachments
5.2.1 Mowing heads
1 STIHL SuperCut 20‑2
2 STIHL AutoCut C 25-2
3 STIHL AutoCut 25-2
4 STIHL TrimCut 31-2
5 STIHL DuroCut 20-2
6 STIHL PolyCut 20-3
5.3 Deflector
7 Deflector for mowing heads
0458-480-0121-B
2
5
WARNING
Never use wire in place of the nylon mowing line
– risk of injury.
4 Approved MultiEngines
Only use MultiEngines supplied by STIHL or
expressly approved by STIHL for use with the
MultiTool.
This MultiTool may only be used in combination
with the STIHL MM 56 MultiEngine.
Deflector
3
6
6 Fitting, removing the Multi‐
Tool
6.1 Mounting the MultiTool
Remove the gearbox
2
► Loosen the clamp screws (1) and pull the
gearbox (2) off the drive tube.
7
1
1
English
7