Jenn-Air Luxury Series Service Manual page 44

IN
OUT
16021730 Rev. 0
PI - START & STOP TEST
Temperature select switch in °C check for 5 V on JP6-1,2.
°F check for 0 V on JP6- 1,2.
PI - START & STOP TEST
If display does not change. Verify communications by
removing tape from FF door switch. HPSC’s should light.
PI - START & STOP TEST
Verify 26 V on JP13-1 remove By Pass.
Verify 0 V on JP13-1
PI - START & STOP TEST
Filter in 26 V on JP13-2 remove filter.
0 V on JP13-2
PI - START & STOP TEST
Measure line voltage at JP8-1,3 when actuator pushed
PI - START & STOP TEST
Measure line voltage at JP8-1,7 when actuator pushed
44