Pushing The Machine By Hand - Toro TimeCutter SW 4200 Operator's Manual

2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers
closest height-of-cut position.
G010233
3
1
1. Anti-scalp roller
2. Bolt

Pushing the Machine by Hand

Important: Always push the machine by hand. Do not
tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and to push
the machine, the ignition key needs to be in the Run position.
The battery needs to be charged and functioning for the
electric brake to be disengage.
Pushing the Machine
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Set the parking brake, stop the engine, and wait for
all moving parts to stop before leaving the operating
position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place
Note: Ensure this is done for each lever.
5. Turn the ignition key on and disengage the parking
brake.
Note: Do not start the machine.
Note: The machine is now able to be pushed by hand.
(Figure 18) to match the
4
2
Figure 18
3. Flange nut
4. Hole spacing
(Figure 19).
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When finished, ensure that the key has been returned to
the Stop position to avoid draining the battery charge.
Note: If the machine fails to move, the electric brake may
still be engaged. If necessary, the electric brake can be released
manually; refer to Releasing the Electric Brake (page
Operating the Machine
Move the bypass levers rearward through the key hole and
down to lock them in place as shown in
Note: Ensure this is done for each lever.
25
1 2
Figure 19
3. Lever position for pushing
the machine
Figure 19.
3
g017303
42).