1. Positive battery post
2. Negative battery post
Installing the Battery
1. Position the battery in the tray
2. Install the positive (red) battery cable to the positive (+)
battery terminal using the fasteners removed previously.
3. Install the negative battery cable to the negative (-)
battery terminal using the fasteners removed previously.
4. Slide the red terminal boot onto the positive (red)
battery post.
5. Secure the battery with the hold-down
6. Lower the seat.
Figure 45
3. Red (+) charger lead
4. Black (-) charger lead
(Figure
44).
(Figure
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse type:
•
Main—F1-30 amp, blade-type
•
Charge Circuit—F2-25 amp, blade-type
1. Remove the screws securing the control panel to the
machine.
Note: Retain all fasteners.
2. Lift the control pane up to access the main wiring
harness and fuse block
3. To replace a fuse, pull out on the fuse to remove it
(Figure
44).
1. Main—30 amp
4. Return the control panel to its original position.
Note: Use the screws removed previously to secure
the panel to the machine.
41
(Figure
46).
46).
1
2
Figure 46
2. Charge circuit—25 amp
G014921