Kenwood KAC-X810D Instruction Manual page 8

Comection
n
Power wire connection
The connecting cord drameter*
l
If solid wire: 00.4 (AWG 26) - 01.2 (AWG 161
l
If m$i strand wrre: 00.4 (AWG 26)- 01.2 (AWG 161
f-l
External amplrfier control
wire (Pink / Black)
(Refer to page 71
CENTER UNIT
Lead terminal* l ****
Battery wire*
Power control wrre
* : Commercially available parts 1
1 AWARNING 1
Battery
To prevent fire caused by a short in the wiring, connect a fusrble lank or breaker nearby the battery's
positive terminal.
Wiring
*Take the battery wire for this unit directly from the battery, If it's connected to the vehicle's
wiring harness, it can cause blown fuses etc.
l
If a buzzing noise is heard from the speakers when the engrne is running, connect a line noise
filter (optional) to each of the battery wrre.
l
Do not allow the wire to directly contact the edge of the iron plate by using Grommets.
l
Connect the ground wire to a metal part of the car chassrs that acts as an electncal ground
passing electricity to the battery's negative @ terminal. Do not turn the power on rf the ground
wire is not connected.
l
Be sure to install a protectrve fuse in the power cord near the battery. The protective fuse
should be the same capacity as the unit's fuse capacity or somewhat larger.
l
For the power cord and ground, use a vehicle type (fireproof) power wring cord with a current
capacity greater than the unit's fuse capacity. (Use a power wiring cord with a diameter of 14
mm2 (AWG 61 or greater.)
l
When more than one power amplifier are going to be used, use a power supply wiring wire and
protective fuse of greater current-handling capacity than the totaf'maximum current drawn by
each amplifier.
.s
EXT.AMP.CONT. (external amplifier control) terminal @
I, Peel the cladding of wire for a length of 11 mm from the end.
2, While pressing the lock release button with a slotted screwdriver, insert the wrre.
8 English