Kenwood KAC-X810D Instruction Manual page 7

Connection ,
W Terminal names
0 Fuse (25 A x 3)
@ Battery terminal
@I Ground terminal
@ Speaker output terminals
As this unit accepts speakers with a
mrnrmum Impedance of I ohm, connect
speakers wrth l-ohm or higher impedance
to these termrnals.
1 ACAUTION 1
The rated Input of the speakers should be
no less than the maxrmum output of the
amplrfrer. Otherwise malfunction may
result.
@I RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
@I LINE IN terminal
@I LINE OUT terminal
The signal that's input from the lrne Input
termtnal is output.
@ Power control terminal
Controls the unit ON/OFF.
f-7EE-q
Controls the unit power, Be sure to connect it
with all the systems,
@ EXT.AMP.CONT. (external
amplifier control) terminal
Controls the 6.M.S. Only Kenwood center
unit models sold rn 1999 or later with a
"EXT.CONT."/'EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
pzEq
There are cases when operation may not be
possible due to wiring wire type and length.
English 7