Table of Contents
Advertisement
3. Confi rming the confi guration change
Press the MENU button and return to the full main menu, same as in step 1. Press either + or - button to move the cursor " "
and select "PRESENT STATE".
Press the MENU button and the PRESENT STATE submenu with the selected confi guration number appears.
The following picture shows the case when confi guration 2 was selected.
NOTE:
The OSD menu disappears in 15 seconds.
Automatic input source detection
By default, the automatic scanning for input signals is enabled. The function is selectable as follows.
Automatic scanning setting
1. Displaying the OSD main menu
Press and hold the MENU button for 2 seconds. The OSD main menu appears.
Press either + or - button to move the cursor " " and select "INPUT SOURCE AUTO SCANNING".
2. Changing the input signal scanning function
Press the MENU button and the INPUT SOURCE AUTO SCANNING submenu appears.
Press either + or - button to move the cursor " " and select the preferred setting.
Input Source Auto Scanning
Disable
Enable*
* "Enable" is selected by default.
Press the MENU button to return to the full main menu, same as in step 1.
NOTE:
The OSD menu disappears in 15 seconds.
Full Menu
PRESENT STATE
Input Source Auto Scanning
INPUT SOURCE AUTO SCANNING
Disables the automatic scanning function.
Enables the automatic scanning function.
English-24
Confi guration number
Explanation
Advertisement
Table of Contents
