Specifications; Standard Accessories; Prior To Operation - Hitachi Koki CR13VC Handling Instructions Manual

SPECIFICATIONS

Voltage
Power Input
Capacity
No-Load Speed
Stroke
Weight (without cord)

STANDARD ACCESSORIES

(1) Blade (No. 103) .................................................... 1
(2) Case ........................................................................ 1
(3) Hexagonal bar wrench ........................................ 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
(1) No. 1 Blade
(2) No. 2 Blade
(3) No. 3 Blade
(4) No. 4 Blade
(5) No. 5 Blade
(6) No. 8 Blade
(7) No. 9 Blade
(8) No. 95 Blade
(9) No. 96 Blade
(10) No. 101 Blade
(11) No. 102 Blade
(1) – (9) : HCS Blades (HCS : Highspeed Carbon Steel)
(10) – (20) : Bl-METAL Blades
Refer to Table 1, 2 and 3 for use of the blades.
Optional accessories are subject to change without notice.
APPLICATIONS
Cutting pipe and angle steel.
Cutting various lumbers.
Cutting mild steel plates, aluminum plates, and copper
plates.
Cutting synthetic resins, such as phenol resin and
vinyl chloride.
For details refer to the section entitled "SELECTION OF
BLADES".

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power requirement specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If
the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
(12) No. 103 Blade
(13) No. 104 Blade
(14) No. 105 Blade
(15) No. 106 Blade
(16) No. 107 Blade
(17) No. 108 Blade
(18) No. 121 Blade
(19) No. 131 Blade
(20) No. 132 Blade
(21) Cut-off guide for pipe
240V
1010 W
Mild Steel Pipe:
Vinyl Chloride Pipe:
Wood:
Mild Steel Plate:
0 – 2800 /min
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be kept
as short as practicable.
4. Mounting the blade
This unit employs a detachable mechanism that
enables mounting and removal of saw blades without
the use of a wrench or other tools.
(1) Turn on and off the switching trigger several times
so that the lever can jump out of the front cover
completely. Thereafter, turn off the switch and unplug
the power cord. (Fig. 1)
CAUTION
Be absolutely sure to keep the switch turned off and
the power cord unplugged to prevent any accident.
Lever
(2) Push the lever in the direction of the arrow mark
shown in Fig. 2 marked on the lever.
Lever
O.D. 130 mm
O.D. 130 mm
Depth 300 mm
Thickness 19 mm
29 mm
3.3 kg
Front cover
Fig. 1
Fig. 2
2