Carrying power tools with your fi nger on the switch GENERAL POWER TOOL SAFETY or energising power tools that have the switch on WARNINGS invites accidents. d) Remove any adjusting key or wrench before WARNING turning the power tool on. Read all safety warnings and all instructions.
c) When battery pack is not in use, keep it away ○ Pull the back of the saw blade two or three times by hand from other metal objects, like paper clips, coins, and check that the blade is securely mounted. When keys, nails, screws or other small metal objects, pulling the blade, you will know it is properly mounted if it that can make a connection from one terminal to...
25. Avoid plunge cutting for metallic materials. This can CAUTION easily damage the blade. 1. If liquid leaking from the battery gets into your eyes, 26. Never pull the switch trigger while the tip of the saw do not rub your eyes and wash them well with fresh blade tip is pressed against the material.
Thickness 10 mm sure that you understand their meaning before use. Weight 3.3 kg 3.4 kg CR14DSL / CR18DSL: Cordless Reciprocating Saw NOTE Due to HITACHI’s continuing program of research and Read all safety warnings and all instructions. development, the specifi cations herein are subject to change without prior notice.
Page 6
Table 1-a Indications of the pilot lamp Lights for 0.5 seconds. Does not light for 0.5 Before Blinks seconds. (off for 0.5 seconds) charging Lights continuously While charging Lights Lights for 0.5 seconds. Does not light for 0.5 Charging Blinks seconds.
● Regarding the temperatures and charging time of the battery. The temperatures and charging time will become as shown in Table 2. Table 2 Charger UC18YFSL UC18YSL3 Battery Charging voltage 14.4 – 18 Weight Temperatures at which the battery can be 0oC –...
Table 5: Selection of blades for other materials SELECTION OF BLADES Material to Material Thickness Blade No. To ensure maximum operating effi ciency and results, it is be cut quality (mm) very important to select the appropriate blade best suited to Iron plate Mild steel No.
Page 9
CAUTION Be absolutely sure to insert the nail of the carbon brush into the contact portion outside the brush tube. (You can insert whichever one of the two nails provided). Caution must be exercised since any error in this operation can result in the deformed nail of the carbon brush and may cause motor trouble at an early stage.