Ford 2016 Fusion Owner's Manual page 285

pressure gauge reading will indicate
the tire inflation pressure after about
30 seconds of operation. The final tire
pressure should be checked with the
compressor turned OFF in order to get
an accurate pressure reading.
E175982
9. When the recommended tire pressure
is reached, turn off the kit, unplug the
power cable, and disconnect the hose
from the tire valve. Re-install the valve
cap on the tire valve and return the kit
to the stowage area.
10. Immediately and cautiously, drive the
vehicle 4 miles (6 kilometers) to
distribute the sealant evenly inside
the tire. Do not exceed 50 mph (80
km/h).
11. After 4 miles (6 kilometers), stop and
check the tire pressure. See Second
stage: Checking tire pressure.
Fusion/Mondeo (CC7) Canada/United States of America, enUSA, First Printing
Wheels and Tires
Note: If you experience any unusual
vibration, ride disturbance or noise while
driving, reduce your speed until you can
safely pull off to the side of the road to call
for roadside assistance. Note: Do not
proceed to the second stage of this
operation.
Second Stage: Checking Tire
Pressure
and have injected sealant in the tire and
the pressure is below 20 psi (1.4 bar),
continue to the next step.
Check the air pressure of your tires as
follows:
E175983
1.
2. Firmly screw the air compressor hose
3. Push and turn the dial clockwise to the
282
WARNINGS
If you are proceeding from the First
Stage: Re-inflating the Tire with
Sealing Compound and Air section
The power plug may get hot after use
and should be handled carefully
while unplugging.
Remove the valve cap from the tire
valve.
onto the valve stem by turning
clockwise.
air position.