Pfaff Smarter Owner's Manual page 30

Standard Buttonhole
(model 130s/140s)
The fabric should be interfaced and/or stabi-
lized where buttonholes are to be sewn.
Prepare the Buttonhole
Measure diameter and thickness of the but-
tain correct buttonhole length. Mark the start
position and buttonhole length on the fabric
Note: Before starting to sew any buttonhole, al-
ways push the the buttonhole foot fully back. The
red marks are arranged at an interval of 0.5 cm.
They are a guide when determining the length of
the buttonhole.
Place the fabric under the foot, so that the
the foot, so that the buttonhole center line
marked on the fabric aligns with the center
Sew the Buttonhole
1
Cut the top thread after a few stitches.
2. Raise the needle to its highest position.
2
3. Raise the needle to its highest position.
3
buttonhole until it matches the previous
side in length.
4. Raise the needle to its highest position.
2
5. To secure the buttonhole, thread the top
thread into a needle, pull to the wrong
side and tie the end before cutting excess
thread.
30
and sew the right side of
and sew a few bartacks.
4
and sew the left side of the
and sew a few bartacks.
4
stitch
2 3
1 4
Set for buttonhole
-
A
1 2
5
6 3-5 5A
B
3 4