GE XL Use And Care & Installation Manual page 32

GENERAL
Dimensions and Clearances in this section
See
for all rough-in and spacing dimensions. These
dimensions must be met for safe use of your range.
The location of the electrical outlet and pipe opening
(see Gas Pipe and Electric Outlet Locations) may
be adjusted to meet spectic requirements.
range may be placed with O" clearance
The
(flush) at the back wdl and sidewalls of the range.
Do not locate the range where it may be subject
to strong drafts. Any openings in the floor or wall
behind the range should be sealed. Make sure
the openings around the base of the range that
supply fresh air for combustion and ventilation
are not obstructed by carpeting or woodwork.
PROTECT YOUR FLOOR
Your range, like many other household items, is
heavy and can settle into soft floor coverings
such as cushioned vinyl or carpeting. Use care
when moving the range on this type of flooring.
It is recommended that the following simple and
inexpensive instructions be followed to protect
your floor.
(or similar material). men the floor covering end
will rest on should be built up with plywood to
the same level or higher than the floor covering.
This will allow the range to be moved for cleaning
or servicing.
MODEL AND SERIAL NUMBER LO~TION
Depending on your range, you'll find the model
and serial numbers on a label on the front frame
of the range, behind the storage drawer, kick
panel or broiler drawer.
32
TOOLS YOU WILL NEED
.
Phillips and flat-blade screwdrivers
Pencil and ruler
Two pipe wrenches (one for backup)
1%" open-end or adjustable wrench
Nut drivers or wrenches: 3/16" and 1/4"
ADDITIONAL WTERIALS YOU WY NEED
line shut-off valve
Gas
Pipe joint sealant or UL-approved pipe thread
tape with Teflon* that resists action of natural
and LP gases
Flexible metal appliance connector (1/2" I. D.)
A 5-foot length is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
Flare union adapter for connection to gas
supply line (3/4" or 1/2" NPTx 1/2" I. D.)
Flare union adapter for connection to pressure
regulator on range (1/2" NPTx 1/2" I. D.)
*Teflon: Registered trademark of DuPont
PREPARATION
Remove all tape and packaging. Lift up the
and remove any packing material under it. Make
sure the standard twin burners are properly
seated and level.
Remove plastic film that covers some chrome
parts (around oven door, side trim).
Check to be sure that no range parts have
come loose during shipping.