Table of Contents
Advertisement
USING THE PHONE
- Press one of the direct memory buttons, M1, M2, CS.
Or press M and any button 0 to 9 on the key pad under which you
wish to store the telephone number in indirect memory.
-
Replace the handset.
Note : Numbers will be lost if you disconnect your phone. Entering
a new number in memory will automatically erase the previous
number.
9 - Dialling Stored Number
- Lift the handset and await the dial tone.
- Press appropriate direct memory button M1, M2, or CS. The
stored number will be dialled out automatically.
Or press the M button followed by the keypad 0 to 9 button under
which the desired number is stored. The stored number will be
dialled out automatically.
To register your stored phones numbers, use the index located on
the base.
10 - Voice Meter Function
Push
switch to adjust voice level meter ON
and OFF
.
On mode:
When unit is off-hook, the voice meter LEDs inside the memory
card cover will indicate the outgoing voice level on telephone line.
Off mode:
When unit is off-hook, the voice meter is turned off.
11 - Hold Function
The Hold function is designed to stop conversation temporarily.
Hold On:
In off-hook state, to press "HOLD" key on the keyboard, the Hold
function is enabled and all speech meter LEDs are turned on.
7
Advertisement
Table of Contents
