Table of Contents
Advertisement
Error Log Utility Procedure
When the System Management Services menu appears, check the error log for any errors. Use the
location code obtained from the SMS error log utility to identify the component the error is reported
against. To obtain the location code from the error log utility do the following:
1. From the SMS main menu, choose View Error Log.
2. If an error is logged, check the time stamp.
3. If the error was logged during the current boot attempt, record it.
4. Look up the error in the Chapter 5, "Error Code to FRU Index," on page 159 and perform the listed
action.
5. If no recent error is logged in the error log, go to "MAP 1540: Problem Isolation Procedures" on page
110.
System Firmware Update Messages
Table 8. System Firmware Update Messages
Error Code Description
A1FD 0000 Recovery mode entered
A1FD 0001 Service processor flash recovery
A1FD 0002 Service processor flash recovery
A1FD 0003 Service processor flash recovery
A1FD 0004 Service processor flash recovery
Scan Dump Messages
Error Code
A100 3000
A1FF 3000
Common Firmware Error Codes
Attention:
Follow the procedure defined in "Checkpoint and Error Code Index" on page 162. If you
replace FRUs or perform an action and the problem is still not corrected, go to "MAP 1540: Problem
Isolation Procedures" on page 110 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to "MAP 0410: Repair Checkout" in the RS/6000
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Table 9. Common Firmware Error Codes
Error Code Description
B006 1403 Missing service processor resource
200
EserverpSeries 615 Service Guide
Description
Successful completion of scan dump
Scan dump has been disabled
Action/
Possible Failing FRU
Information message
Insert Diskette #1
Insert Diskette #2
Insert Diskette #3
Insert Diskette #4
Action/ Possible Failing FRU
Informational message; may or may
not be seen during a scan log dump.
Informational message; may or may
not be seen during a scan log dump.
Action/
Possible Failing FRU
1. Update system firmware
2. Service processor
Location: U0.1-P1-X1
Advertisement
Table of Contents
