Error Code List - Utax 261ci User Manual

Troubleshooting > Error Code List

Error Code List

When a transmission error occurs, one of the following error codes is recorded in the TX/RX Result Report and Activity
Report.
NOTE
"U" or "E" will appear in the error code depending on the communication speed setting.
Error Code
Busy
CANCELED
U00300
U00430 - U00462
U00601 - U00690
U00700
U00800 - U00811
U00900 - U00910
U01000 - U01097
U01100 - U01196
U01400
U01500
U01600
U01700 - U01720
U01721
U01800 - U01820
U01821
U03000
U03200
U03300
Failed to establish connection with the recipient despite auto redialing the preset number of times.
Send again.
Transmission was canceled due to an action to cancel transmission.
Reception was canceled due to an action to cancel reception.
Paper depletion occurred at the recipient machine. Check with the recipient.
Reception was canceled because of mismatching of communication features with the sender machine
although the line connection was established.
Communication was stopped due to the machine failure. Send or receive again.
Communication was stopped due to failure on the part of the sender or recipient machine.
Page(s) not sent correctly. Send again.
Page(s) not received correctly. Ask the sender to resend.
Communication error occurred during transmission. Send again.
Communication error occurred during reception. Ask the sender to resend.
Failed to establish communication with the sender or recipient machine because dialing registered for
a push line system was used in a pulse line system.
Communication error occurred during high-speed transmission. Send again.
Communication error occurred during reception of high-speed transmission. Ask the sender to reduce
the transmission speed and send again.
Communication error occurred during high-speed transmission. Send again.
Communication error occurred during high-speed transmission. Designated transmission speed may
not be available for the recipient machine.
Reduce the transmission start speed and send again.
Communication error occurred during reception of high-speed transmission. Ask the sender to reduce
the transmission speed and send again.
Communication error occurred during reception of high-speed transmission. Designated transmission
speed may not be available for this machine. Ask the sender to reduce the transmission speed and
send again.
During polling reception, a fax could not be received because no originals were set in the other party's
fax machine. Check with the other party.
Sub address bulletin board reception was attempted and the other party's machine is an our brand
model, but the specified sub address box contained no data. Check with the other party.
An error occurred due to either 1 or 2 below.
Check with the other party.
1 The other party's machine is an our brand model and transmission restrictions were found set by
the other party during polling reception. Communication was interrupted because the password was
incorrect.
2 The other party's machine is an our brand model and transmission restrictions were found set by
the other party during sub address bulletin board reception.
Communication was interrupted because the password was incorrect.
Possible Cause/Action
10-5