Insert The Batteries - Hitachi VZ-HD4000A User Manual

Information on DVI-I and 3G-SDI/HD-SDI Cables
l DVI-I and 3G-SDI/HD-SDI cables do not come with the product. Please
purchase them separately to match the specifications of your monitor or other
external device. Refer to pages 23, 24 and 25 for information on cable types.
Alternatively, refer to page 63 for the terminal specifications for DVI-I cables.
Information on Serial Interface Cables
l An RS-232C cable do not come with the product. If you wish to use an
RS-232C cable and control the camera via an external device, purchase
an RS-232C cable that conforms to the terminal specifications on page 64.
l If you wish to use an RS-422 cable, use the included RS-422 terminal block
connector and make connection cables. When making cables, refer to the wiring
diagrams on page 64 for pin layout and page 65 for the wiring diagram of RS-422
cables. Also, refer to page 66 for how to use RS-422 terminal block connector.
 Getting the Remote Control Ready
Caution
Warnings about Using Dry Cell Batteries
Ÿ Do not use any batteries in this device except those specified. Also, do
not mix old and new batteries. Doing so may cause fire or injury due to
the batteries exploding or leaking.
Ÿ Load the batteries as indicated on the device and make sure they are
facing correctly in terms of polarity. Incorrect polarity may result in injury or
staining of the surrounding area due to the batteries exploding or leaking.
Remove the battery-
chamber lid
1
Open the lid by pressing in
the direction of the arrow.

Insert the batteries

Insert the included AAA
2
batteries with (+)(-) as
indicated.
Close the battery-
chamber lid
3
Press in the direction of the arrow
and put the lid back in place.
11