Safety; To Order Parts - Keystoker Koker with Thermostat Installation Instructions Manual

Installation Instruction for Koker with thermostat
Fan blades on combustion motor dirty. Brush off. Accumulated fly ash under grate.
Remove combustion motor and clean under grate. Holes blocked in grate. Open holes
with 1/8 center punch (See Page 6 Diagram (1).
TO CLEAN UNDER OR REPLACE GRATE See Page 2 (Cleaning & Lubrication)
NYLON CAM MELTS
Under normal operating conditions, nylon cam will not melt. Melting of nylon cam can
only be caused by a draft problem.
A blockage in chimney, chimney connector, stove pipe, or stove. Inspect and clean.
Or excessive draft, caused by high chimney, large flue, or high winds. Clean and adjust
barometric damper. (Set barometric damper with a draft gauge to obtain a draft reading
of -.02 to -.03, See Page 2 Draft Check)

TO ORDER PARTS

Find the metal 1 ½" x 3" Keystoker label fastened to stoker unit body, near gear motor.
The four or five digit number will be required to get proper replacement parts from your
dealer.
THE BURNING OF ALL FOSSIL FUELS GENERATES CARBON MONOXIDE GASES.
CARBON MONOXIDE GASES ARE TOXIC, CAN CAUSE SICKNESS OR BE FATAL
To prevent toxic carbon monoxide gases from entering the home, certain
precautions must be taken.
Ash tub must be emptied on a regular basis to prevent ashes from overflowing
into ash pit area. Excessive ash accumulation may impede air flow to chimney,
preventing gases to be drawn up chimney.
Fire door and ash door must be kept closed at all times during normal operation.
It is necessary to keep coal in hopper while stove is in operation.
In most applications it is sufficient to clean stove and stove pipe twice during
heating season. However, under extreme weather conditions, or high demand on stove
running periods, the stove and stove pipe may need more frequent cleaning. Clean as
often as necessary.
CAUTION: ASH PAN IS HOT-Always Use Gloves to Remove Ash Pan
Before removing ash pan, turn switch off, or pull power cord plug from 110V
outlet. Open ash door. Use a good pair of gloves, to remove ash pan. Place filled ash
pan on a non-combustible surface. Slide an empty ash pan into stove. Close ash door.
Turn switch on or plug power cord back into 110V outlet.
BIG FIRE BUT NOT MUCH HEAT

SAFETY

14
.