Table of Contents
Advertisement
Installation Instruction for Koker with thermostat
RELAY-receives signal from 24V thermostat to turn on or turn off gear motor.
CONVECTION BLOWER-when running, it will take cool air from room, and force it
through heated air chamber inside stove, and return heated air into room. Blower can
only be activated by Fan Limit Switch.
HOW TO REMOVE OR REPLACE GEAR MOTOR
TO REMOVE GEAR MOTOR: FIRST...Pull power cord pug from 115V outlet.
Remove Coal from hopper. Remove 10-24 machine screw and then remove protective
cage. Disconnect both blue wire nuts marked. Remove both 10-24 machine screws
from mounting bracket. Slide gear motor out of its track toward you, pusher bar will
also come out with gear motor.
While pusher bar is out of its chute, clean chute area and remove any obstructions.
Check nylon screws on pusher bar (2 on each side) for wear or breakage. (Replace if
necessary)
Slide pusher bar in and out of chute (should move freely) check for sideward movement.
Adjust nylon screws on right side to allow only a slight sideward movement.
TO REPLACE GEAR MOTOR: -remove (4) 10-32 machine screws that hold gear
motor onto mounting bracket. Before removing gear motor from bracket, look at
position of gear motor; install new motor in exact same position before reinstalling
screws. Then reverse procedures and reinstall.
11
Advertisement
Table of Contents
