Table of Contents
Advertisement
installing the driver.
13. The wizard will now copy the required files to the system and start the Driver. After
starting the driver the wizard will display a completion dialog, click 'Finish' to exit
the wizard.
4.3. Windows XP installation
1.
Power off the system. Insert Combo Card into an available PCI slot. Power up the
system.
2.
During OS boot up, Windows will display the 'Found New Hardware Wizard'.
'Universal Serial Bus (USB) controller'.
3.
Select 'Install the software automatically (Recommended)' and insert diskette
driver into Floppy disk drives. And click 'Next'.
4.
If the 'Hardware Installation' dialog appears, click 'Continue Anyway'.
5.
The wizard will now copy the required files to the system and start the Driver. After
starting the driver the wizard will display a completion Dialog, click 'Finish' to exit
the wizard.
6.
Windows will display the 'Found New Hardware Wizard'. 'Mass Storage Controller'.
7.
Select 'Install the software automatically (Recommended)'. Click 'Next'.
8.
If the 'Hardware Installation' dialog appears, click 'Continue Anyway'.
9.
The wizard will now copy the required files to the system and start the Driver. After
starting the driver the wizard will display a completion Dialog, click 'Finish' to exit
the wizard.
4.4.
Verifying The installation under Windows 2000 and XP
Follow the instructions in this section to verify that the controller was installed
correctly.
1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware'
tab, and then on 'Device Manager' button.
2. Double click on 'System devices', then left click on 'PCI standard PCI-to-PCI
bridge '. If there is no yellow '!' or '?' in front of 'PCI standard PCI-to-PCI bridge' the
driver has started correctly.
3. Double click 'Universal Serial Bus Controllers', If there is no yellow '!' or '?' in front of
NEC PCI to USB Enhanced Host Controller
NEC PCI to USB Open Host controller
NEC PCI to USB Open Host controller
USB Root Hub
- 7 -
Advertisement
Table of Contents
