HPWH 300 - HPWH 300HE Please read 1.3 Regulations / safety immediately information NOTE 1.1 Important notes Read these installation operating instructions before commissioning! ATTENTION! The domestic hot water heat pump is used exclusively to Work on the domestic hot water heat pump may only be performed by heat water for domestic use and drinking water within the qualified personnel.
HPWH 300 - HPWH 300HE Description 2.2 Refrigerant circuit (heat pump operating principle) 2.1 General The refrigerant circuit is a closed system in which the R134a re- frigerant is the energy source. The finned heat exchanger ex- The domestic hot water heat pump is a ready-for-use heating de-...
HPWH 300 - HPWH 300HE Storage and transport Heating element temperature controller (TC) The heating element thermo controller regulates the domestic hot water temperature during heating element operation. The 3.1 General maximum controller temperature is factory set to 65 °C (the con- troller and the STL are installed together in a casing).
HPWH 300 - HPWH 300HE Installation Assembly 4.1 Installation location 5.1 Connecting the water pipes Condensate drainage (with a siphon) must be provided. The water connections (see Cap. 1 on pag. II) are located on the rear of the unit.
HPWH 300 - HPWH 300HE Commissioning 5.2 Connecting the condensate hose 6.1 Domestic hot water system The condensate hose is routed out through the sheet metal cov- ering. It should be routed in such a way that the condensate pro-...
HPWH 300 - HPWH 300HE Maintenance / repair "Heating Element" switch If there is an increase in hot water consumption or if a higher hot water temperature (60±2°C) is desired, the “heating element” ATTENTION! switch can be used to switch the integrated 1.5 kW radiator on.
HPWH 300 - HPWH 300HE Faults / troubleshooting 7.3 Corrosion protection anode (for the user) The corrosion protection anode installed in the domestic hot water cylinder should be electrically checked on a regular basis (at least every two years after commissioning) and be replaced ATTENTION! as necessary.
HPWH 300 - HPWH 300HE 11 Device information Type and order code HPWH 300 HPWH 300HE Design Defrosting Nominal cylinder volume litre Transfer area of the internal heat exchanger m 1.45 Sensor pipe ø for external sensors internal Installation location...
HPWH 300 - HPWH 300HE 2 Integration Diagram 2.1 Process circuit diagram 2.2 Legend Compressor Evaporator Hot water cylinder with Liquifier High-pressure switch Check valve Air inlet temperature sensor (R1) Filter dryer Expansion valve Cylinder temperature sensor Heating element Safety temperature limiter for heating element...
HPWH 300 - HPWH 300HE 2.3 Hydraulic integration diagram 2.4 Legend Shutoff valve Pressure reducing valve Test valve Return flow inhibitor Pressure gauge connecting stubs Drain valve Safety temperature pressure valve (PTR valve) There must be no shut-off device between the cylinder and the safety valve (PTR valve).