Only For Training And Service Purposes - LG L705i Service Manual

3.3.1 Transmitter
The UMTS Tx path begins with differential baseband signals (I and Q) from the MSM device. These
analog input signals are amplified, filtered, and applied to the quadrature up-converter mixers. The up-
converter output is amplified by multiple variable gain stages that provide transmit AGC control. The
AGC output is filtered and applied to the driver amplifier; this output stage includes an integrated
matching inductor that simplifies the external matching network to a single series capacitor to achieve
the desired 50-ߟ interface.
The RTR6275 UMTS output is routed to its power amplifier through a bandpass filter, and delivers fairly
high-level signals that are filtered and applied to the PA. Transmit power is delivered from the duplexer
to the antenna through the switch module.
The transceiver LO synthesizer is contained within the RTR6275 IC with the exception of the off-chip
loop filter components and the VC-TCXO. This provides a simplified design for multimode applications.
The PLL circuits include a reference divider, phase detector, charge pump, feedback divider, and digital
logic generator.
UMTS Tx. Using only PLL1, the LO generation and distribution circuits create the necessary LO signals
for nine different frequency converters.
the UMTS transmitter also employs the ZIF architecture to translate the signal directly from baseband to
RF. This requires F to equal F
LO
equal F .
RF
The RTR6275 IC is able to support UMTS 2100/1900 and UMTS 800 mode transmitting. This design
guideline shows only UMTS 2100/1900 and UMTS 800 applications.
Copyright © 2007 LG Electronics. Inc. All right reserved.

Only for training and service purposes

, and the RTR6275 IC design achieves this without allowing F
RF
- 25 -
3. TECHNICAL BRIEF
LGE Internal Use Only
to
VCO