GMSK-modulated or 8-PSK-modulated signal to RF. Fig 3.1 Block diagram of RF part A generic, high-level functional block diagram of L705i is shown in Figure 1-1. One antenna collects base station forward link signals and radiates handset reverse link signals. The antenna connects with receive and transmit paths through a FEM(Front End Module) (plus two duplexers for UMTS high-band and lowband operations).
2. The amplitude-modulated (AM) component is applied to the ramping control pin of Polar power amplifier from a DAC within the MSM L705i power supply voltages are managed and regulated by the PM6650 Power Management IC. This versatile device integrates all wireless handset power management, general housekeeping, and user interface IC and higher-level handset functions.
GSM900, DCS and PCS). The antenna switch module allows multiple operating bands and modes to share the same antenna. In L705i, a common antenna connects to one of eight paths: 1) UMTS-800 Rx/Tx, 2) UMTS-1900 Rx/Tx, 3) GSM-850 Rx, 4) GSM-900 Rx, 5) GSM-850 GSM-900 Tx, (Low Band Tx’s share the same path) 6) DCS- 1800 Rx, and 7) DCS-1800,PCS-1900...
Important performance requirements include; ■ Insertion loss: This component is also in the receive and transmit paths; In the L705i typical losses: UMTS2100_ Tx = 1.6dB, UMTS2100_ Rx = 2.1dB and UMTS800_ Tx =1.0dB, UMTS800_ Rx = 1.5dB ■...
3. TECHNICAL BRIEF L705i has a protective circuit for non-booting from USB. When the phone is booted from USB_VBUS without Battery, booting current might be insufficient. Sometimes, this scheme can break the USB port on a computer. So, L705i does not support booting from USB.
3.11.8. LCD Module (IM240DST2A : LG innotek LCD module) - The IM240DST2A model is a Color TFT Main LCD supplied by LG innotek. This main Module has a 2.4 inch diagonally measured active display area with 240(RGB)X320 resolution. Each pixel is divided into Red, Green and Blue sub-pixels and dots which are arranged in vertical stripes.
µA Control current max µS Switching Speed * L705i WB2100 band uses WB1900 path in the FEM. So the FEM logic is changed from (1,0,1) to (0,0,1). Logic Table of the Front End Module Check Soldering of ANT_SEL 0,1,2 High Level Check Vdd 1.5V<Voltage<3.0V...
4. TROUBLE SHOOTING 4.8. USB Troubleshooting USB Initial sequence of L705i is: USB connected to L705i power on → USB_VBUS(Q402 PIN4) go to 5V → USB_D+ go to → 3.3V→ USB_VP and USB_VN is triggered → USB work. Start Go to power on trouble shooting...
LGMDP supports Windows 2000/XP where the LG USB modem driver is installed. Additionally, LGMDP allows multi downloading up to 8 handsets at the same time.