Page 1
Dovre 280 or 425 Electric Instructions for Use, Installation and Servicing For use in GB, IE (Great Britain and Republic of Ireland) IMPORTANT THE OUTER CASING, FRONT AND GLASS PANEL BECOME EXTREMELY HOT DURING OPERATION AND WILL RESULT IN SERIOUS INJURY AND BURNS IF TOUCHED. IT IS THEREFORE RECOMMENDED THAT A FIREGUARD COMPLYING WITH BS 8423:2002 IS USED IN THE PRESENCE OF YOUNG CHILDREN, THE ELDERLY OR INFIRM.
Please note that all warranties Installation ..............7 are effective from the date of purchase. Any Dovre product purchased outside of our Extended Retailer Network, or not registered within the 1. Fitting Appliances ..............7 stated time will carry a standard 12 month warranty.
If the electricity supply cable is damaged do not use the appliance until it has been replaced. For safety reasons the Select the relevant information for your model. replacement has to be carried out by Dovre, a Dovre service agent or a similarly competent electrician. 1. Important Information and 1.15...
Page 4
User Instructions Dispose of old batteries at an appropriate recycling facility. Standby On/Off When using the handset: 2.11 The appliance is in Standby mode when the power is Ensure the handset is pointed at the infrared sensor switched on via the manual control panel. You must have located behind the flame effect screen at the back of the this power supply ON (—) before using the manual or inside of the appliance.
User Instructions CLEANING LOG MOULDING Thermostatic Control Ensure the appliance is unplugged and cold before handling log moulding. 2.21 The appliance is fitted with a thermostat, see Diagram 1, which can control the room temperature between Follow Section 4, choosing relevant model, to access and approximately 9˚C and 34˚C.
Installation Instructions Technical Specification These instructions cover the following models: Model Dovre 280 Dovre 425 Black DV-280E DV-425E White Ivory Enamel DV641-809 DV641-818 These appliances have 3 modes of operation: ALL INGLENOOK FIREPLACE OPENINGS: — Flame effect only - with brightness and flame colour...
Installation Instructions 1. Fitting Appliances Most appliances are heavy and do not require anchoring to the hearth or floor, but in certain circumstances the appliance can become unstable e.g. when leaning on the appliance. If this is likely, secure the appliance to the hearth or floor with suitably strong fixings.
Servicing Instructions Live Wire Brown Terminal L / RED 1. Fault Finding Neutral Wire Blue Terminal N / BLACK Earth Wire Green & Yellow No illumination or uneven lighting: Terminal E / / GREEN or Stripes GREEN & YELLOW Check the heater is working. If YES, one or more of the LED boards will need replacing.
Servicing Instructions Dispose of the board at an appropriate recycling centre. 3. Servicing Requirements To connect the new LED board push the fasteners through the ready drilled holes and ensure that all wires are correctly THIS APPLIANCE MUST ONLY BE SERVICED BY A connected.
Servicing Instructions Disconnect the 2 x wires connecting the 2 x 'flying' LEDs 9. Replacing the Heater Assembly to the front LED board, noting their orientation. Lift and rotate the motor unit to give access to the rear To access the heater assembly remove any loose top plates LED board.
Reattach heater casing to bottom of firebox using 5 x screws. Relocate the appliance to its original position and replace any loose top plates or panels. Spare Parts List Parts Description Part No. Model DOVRE 280 DOVRE 425 Log Fuel Effect PL0117 PL0118 Handset EL0491...