Two Thermistor Control - LG AMNW07GDBL1 Service Manual

6.11 Two Thermistor Control

This is the function to select the temperature sensor to judge the room temperature.
FAN
SPEED
TEMP
<Thermistor Table>
Temperature sensor selection
01 Remote controller
02 Indoor unit
03 2TH
❈ The function of 2TH has different operation characteristics according to the product.
Copyright ©2014 LG Electronics. Inc. All right reserved.
Only for training and service purposes
1
2
OPER
MODE
3
4
Operation in remote controller temperature sensor
Operation in indoor unit temperature sensor
Operation of higher temperature by comparing indoor unit's and wired remote
Cooling controller's temperature.
(There are products that operate at a lower temperature.)
Operation of lower temperature by comparing indoor unit's and wired remote
Heating
controller's temperature.
When pressing the button and
simultaneously for more than 3 seconds, the system will be
entered into the installer setting mode.
- After entering into the installer setting mode, select the
thermistor sensor setting code value by pressing the
button.
* Thermistor sensor selection code value : 04
Select the desired setting value with the temperature up(▲),
down(▼) button.
Code value
Value
When pressing the
thermistor sensor location will be set up.
When pressing the
simultaneously for more than 3 seconds after the setting
has been completed, the setting mode will be released.
- If there isn't any button input for more than 25 seconds,
the installer setting mode will also be released.
Function
- 25 -
Part 2 Functions & Controls
OPER
button
MODE
*Setting value
01: Remote
controller
02: Indoor unit
03: 2TH
button, currently established
OPER
button and button
MODE
LGE Internal Use Only
OPER
MODE