SATO MB400i Operator's Manual page 35

Installing the label roll (cont'd)
3. Close the cover after confirming that the leading
edge of the label is outside the printer by at least
10mm.
* Note: When using linerless labels, press the
FEED button to feed a piece of label and pull the
label upward to cut it along the perforation. If the
label becomes jammed, retry the label setting
procedure.
4. Push the dispenser unit forward so that it covers
the red platen roller.
This completes the label installation for
Dispense mode operation. To resume operation
in Continuous mode, lift the top edge of the
dispenser unit (where two arrow marks are
imprinted) to it downwards. In Continuous
mode, the red platen roller will be visible.
Setup
2-15