Product Specifi C And Important Safety Information; Appliance Certifi Cation; Glass Specifi Cations; Btu Specifi Cations - Heat & Glo RED40 Installation Manual

1 1
Product Specifi c and Important Safety Information
A. Appliance Certifi cation
MODEL: RED40, RED40ST
LABORATORY: Underwriters Laboratories, Inc. (UL)

TYPE: Direct Vent Heater
STANDARD: ANSI Z21.88b-2008 CSA 2.33a-2008
Vented Gas Fireplace Heaters
 This product is listed to ANSI standards for "Vented Gas
Fireplace Heaters" and applicable sections of "Gas Burn-
ing Heating Appliances for Manufactured Homes and
Recreational Vehicles", and "Gas Fired Appliances for
Use at High Altitudes".
NOTICE: This installation must conform with local codes.
In the absence of local codes you must comply with the
National Fuel Gas Code, ANSI Z223.1-latest edition in
the U.S.A. and the CAN/CGA B149 Installation Codes in
Canada.
NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.
This appliance is tested and approved as either supplemen-
tal room heat or as a decorative appliance. It should not be
factored as primary heat in residential heating calculations.
B. Glass Specifi cations
This appliance is equipped with 5 mm ceramic glass. Re-
place glass only with 5 mm ceramic glass. Please contact
your dealer for replacement glass.
C. BTU Specifi cations
Models
(U.S. or Canada)
RED40
(0-2000 FT)
RED40ST
CANADA
(NG)
(2000-4500 FT)
RED40
(0-2000 FT)
RED40ST
CANADA
(LP)
(2000-4500 FT)
4
Minimum
Maximum
Input
Input BTU/h
BTU/h
US
34,000 24,000
29,500 22,000
US
34,000 25,000
31,500 23,000
Heat & Glo • RED40, RED40ST Installation Manual • 2155-980 Rev. C • 11/13
D. High Altitude Installations
NOTICE: If the heating value of the gas has been reduced,
these rules do not apply. Check with your local gas utility
or authorities having jurisdiction.
When installing above 2000 feet elevation:
• In the USA: Reduce input rate 4% for each 1000 feet
above 2000 feet.
• In CANADA: Reduce input rate 10% for elevations
between 2000 feet and 4500 feet. Above 4500 feet,
consult local gas utility.
Check with your local gas utility to determine proper
orifi ce size.
E. Non-Combustible Materials Specifi cation
Material which will not ignite and burn. Such materials are
those consisting entirely of steel, iron, brick, tile, concrete,
slate, glass or plasters, or any combination thereof.
Materials that are reported as passing ASTM E 136,
Standard Test Method for Behavior of Materials in
a Vertical Tube Furnace at 750 ºC shall be considered
non-combustible materials.
F. Combustible Materials Specifi cation
Materials made of or surfaced with wood, compressed pa-
per, plant fi bers, plastics, or other material that can ignite
and burn, whether fl ame proofed or not, or plastered or
unplastered shall be considered combustible materials.
G. Electrical Codes
NOTICE: This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with National Electric Code
Orifi ce
Size ANSI/NFPA 70-latest edition or the Canadian Electric
(DMS)
Code CSA C22.1.
#34
• A 110-120 VAC circuit for this product must be pro-
tected with ground-fault circuit-interrupter protection,
#36
in compliance with the applicable electrical codes,
when it is installed in locations such as in bathrooms
#50
or near sinks.
#51