Axis P1365-E Installation Manual page 24

AXIS P1365-E Network Camera
4
1
Holder screw T20 (2x)
2
Holder
3
Position A (overlap) : +3.7 mm (+0.15 in)
4
Position B (gap) : -6 mm to -4 mm (-0.24 in to -0.16 in)
NO TICE TICE
NO NO TICE
• Position A: To avoid reflections in the image, adjust the holder's position so that the
camera lens edge overlaps the bottom cover edge by +3.7 mm (+0.15 in). Note that
this position voids the IK10 rating.
• Position B: To fullfill the IK10 rating requirements, adjust the holder's position so
that the gap between the camera lens and bottom cover edges is between -6 mm and
-4 mm (-0.24 in and -0.16 in).
5. Connect the heater cable to the heater connector in the bottom cover.
6. If using an SD card for local storage, insert the card into the camera's SD card slot.
7. Connect the housing to the network (PoE IN) and the camera to the housing (PoE OUT).
24
2
3