Mount Status - Dell PowerEdge 1400 User Manual

support.dell.com
3. Select the removable-media device.
Drive status options appear as shown in Table 3-2.

   
 
Volume Segments on Drive
Read After Write Verify
1
Drive Light Status
Driver Operating Status
Removable Drive Mount Status
Removable Drive Lock Status
1
Valid for both removable and nonremovable SCSI drives.
2
Valid for removable media only.
.  & '
The Read After Write Verify option is set to Hardware Level by default. This option
cannot be specified in the startup.ncf or autoexec.ncf file. However, the default can
be set on the command line. Refer to the NetWare User's Guide for information about
using the load command-line options.
The available options are defined in Table 3-3.

    !"#!$ 

  
Disabled All writes to SCSI disk drives are executed with the SCSI Write
command (0Ah or 2Ah).
Hardware Level All writes to SCSI disk drives are executed with the SCSI Write
and Verify command (2Eh) or (if this command is not supported
by the drive) with the SCSI Write command (0Ah or 2Ah), fol-
lowed by the SCSI Verify command (2Fh).
Software Level Not supported.
' '
Mounting causes a drive to come online as a NetWare storage device. Dismounted
drives are inactive and cannot be accessed.
   
1
Select for a list
1
Hardware Level
Not supported
1
Active
2
Mounted
2
Not Locked
Installing and Configuring SCSI Drivers 3-13