Table of Contents
Advertisement
REMOTE CONTROL
CAUTION
!
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage.
Handle the control with care and avoid getting the control
wet.
IMPORTANT: The remote control can operate the unit from a
distance of up to 25 ft. (7.6 m) as long as there are no obstructions.
This is one way communication only (from remote control to fan
coil).
The remote control can perform the following basic functions:
S Turn the system ON and OFF
S Select operating mode
S Adjust room air temperature set point and fan speed
S Adjust airflow direction
Refer to the Remote Control Function section for detailed
description of all the capabilities of the remote control.
Battery Installation
Two AAA 1.5 v alkaline batteries (included) are required for
operation of the remote control.
To install or replace batteries:
1. Slide the back cover off the control to open the battery
compartment.
2. Insert batteries. Follow the polarity markings inside the
battery compartment.
3. Replace battery compartment cover.
NOTE:
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote control to malfunction.
2. If the remote is not going to be used for several weeks, remove
the batteries. Otherwise battery leakage may damage the remote
control.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no audible beep from the
indoor unit or if the Transmission Indicator fails to light.
Remote Control Operation - - Quick Start
NOTE: When transmitting a command from the remote control to
the unit, be sure to point the control toward the right side of the
unit. the unit will confirm receipt of a command by sounding an
audible beep.
1. Turn the unit on by pushing the ON/OFF button.
2. Select the desired mode by pushing the mode button.
AUTO
COOL
NOTE: Cool only units have no heat mode.
3. Select the temperature set point by pointing the control
toward the unit and pressing the increase/decrease
temperature set point buttons until the desired temperature
appears on screen.
4. Select the desired fan speed by pressing the FAN SPEED
button to select desired fan speed.
NOTE: If unit is operating in Dry mode the fan will only operate
in low speed and cannot be changed.
5. Set the airflow direction. When the unit is turned on, the
louvers default to the cooling or heating position. The user
can adjust louver position by pushing the air direction
button or have continuous louver movement by pushing the
swing button.
Emergency Operation
If the remote control is lost, damaged, or the batteries are
exhausted, the MANUAL button can be used to run the unit.
Open the front cover panel and press the MANUAL button once
briefly when the system is off.
To stop emergency operation, push the MANUAL button twice or
operate the remote control.
pushed once, the system will enter TEST mode and run for 30
minutes.
The set conditions of emergency operation are as follows:
S Preset set point: 76_F (24_C)
S Fan speed: AUTO
S Discharge air direction: Pre- -set position based on operation in
"Cool"or "Heat" mode.
5
SET TEMPERATURE( F)
O
FAN
AUTO
HIGH
COOL
MED
DRY
LOW
HEAT
TEMP
ON/OFF
MODE
FAN SPEED
SLEEP
TIMER ON
SWING
TIMER OFF
RESET LOCK
AIR
LED
DIRECTION
DISPLAY TURBO
A07542
DRY
FAN
HEAT
If the MANUAL button is only
Manual button
A07364
Advertisement
Table of Contents
