Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and discharge
capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures require power to be
connected. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Wax Motor Detergent / Rinse Dispenser
Removal
1. Disconnect power to the machine.
2. Remove the Inner Door Panel, see "Inner Door Panel"
removal procedure.
3. Remove the 6 mounting screws securing the
Detergent Dispenser mounting bracket.
4. To remove the Wax Motor, pry out of retainer.
NOTE: It is not necessary to remove Detergent
Dispenser before removing Wax Motor.
©2006 Maytag Services
!
WARNING
Vent
The Vent is located on the Inner Door Panel to allow
moisture to be vented outside of the Dishwasher during
the dry cycle.
Removal
1. Disconnect power to the machine.
2. Remove the Inner Door Panel, see "Inner Door Panel"
removal procedure.
3. Rotate Vent Cover counter clockwise 1/4 turn and lift
off.
16026945
21