Scr Operation - Lincoln Electric SQUARE WAVE SVM141-A Service Manual

Lincoln electric welder user manual
Table of Contents

Advertisement

E-7
INPUT
CATHODE
OUTPUT
ANODE
GATE
GATE

SCR OPERATION

A silicon controlled rectifier (SCR) is a three-terminal
device used to control rather large currents to a load.
An SCR acts very much like a switch. When a gate sig-
nal is applied to the SCR, it is turned ON and there is
current flow from anode to cathode. In the ON state
the SCR acts like a closed switch. When the SCR is
turned OFF there is no current flow from anode to cath-
ode. Thus, the device acts like an open switch. As the
name suggests, the SCR is a rectifier, so it passes cur-
rent only during positive half cycles of the AC supply.
The positive half cycle is the portion of the sine wave in
which the anode of the SCR is more positive than the
cathode.
When an AC supply voltage is applied to the SCR, the
device spends a certain portion of the AC cycle time in
the on state and the remainder of the time in the off
state. The amount of time spent in the ON state is con-
trolled by the gate.
THEORY OF OPERATION
FIGURE E.9 – SCR OPERATION
An SCR is fired by a short burst of current into the gate.
This gate pulse must be more positive than the cath-
ode voltage. Since there is a standard PN junction
between gate and cathode, the voltage between these
terminals must be slightly greater than 0.6V. Once the
SCR has fired, it is not necessary to continue the flow
of gate current. As long as current continues to flow
from anode to cathode, the SCR will remain on. When
the anode to cathode current drops below a minimum
value, called holding current, the SCR will shut off.
This normally occurs as the AC supply voltage passes
through zero into the negative portion of the sine wave.
If the SCR is turned on early in the positive half cycle
the conduction time is longer, resulting in greater SCR
output. If the gate firing occurs later in the cycle the
conduction time is less, resulting in lower SCR output.
SQUARE WAVE TIG 275
E-7
NOTE: AS THE GATE
PULSE IS APPLIED
LATER IN THE CYCLE
THE SCR OUTPUT
IS DECREASED.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Square wave tig 275

Table of Contents