Accessories Section; Optional Accessories - Lincoln Electric SQUARE WAVE IM565-B Operator's Manual

10

OPTIONAL ACCESSORIES

K964-1 Undercarriage with Pivoting Single Gas
Cylinder Platform - This undercarriage features a piv-
oting platform to easily load and unload the gas cylin-
der without lifting. It was designed specifically for the
Square Wave TIG 175 power source, and accommo-
dates 7" to 9 1/4" diameter gas cylinders. The under-
carriage comes completely assembled and mounts
directly to the power source.
tm
K812 Hand Amptrol - A Lincoln Foot Amptrol is
included with the Square Wave TIG 175 for remote cur-
rent control while TIG welding.
Amptrol may be used in place of the Foot Amptrol if a
thumb operated remote control is desired.
K814 Arc Start Switch - The Arc Start Switch may be
used instead of the Foot Amptrol included with the
Square Wave TIG 175. It allows on/off TIG welding at
the current set by the Current Control on the control
panel. The Arc Start Switch does not provide remote
current control.
Magnum® LA-9 and LA-17 TIG Torches - The follow-
ing standard Magnum® TIG torches with one-piece
cable may be used with the Square Wave TIG 175.
• K859-1 LA-9 12.5 ft medium back cap
• K859-5 LA-9 25 ft
• K860-1 LA-17 12.5 ft long back cap
• K860-5 LA-17 25 ft
NOTE: Each torch requires a quick connector plug
(S22529-1) and strain relief boot (M17255) be installed
onto the cable. Collets, collet bodies, and nozzles are
not included and must be ordered separately.
Quick Connect Plug (S22529-1) and Strain Relief
Boot (M17255) - One of each is shipped with the
welder to connect the Magnum LA-9 torch. If you do
not care to interchange these parts between torches
(one of each is required to connect Magnum LA-9 or
LA-17 TIG torches with one-piece cable to the Square
Wave TIG 175) you may order additional sets. The
quick connect plug provides connection for both gas
and welding current.
Tungstens, Collets, Collet Holders, Gas Cups,
Backcaps and Other Torch Parts - A Lincoln Magnum
LA-9 with 12.5 ft. one-piece cable is included with the
Square Wave TIG 175. Standard Magnum® parts and
accessories for this torch may be used.
ACCESSORIES
The K812 Hand
medium back cap
long back cap
SQUARE WAVE TIG 175
TIG Torch Parts Kits - Parts kits are available for the
LA-9 and LA-17 TIG torches. These kits include back
cap, collets, collet bodies, nozzles and tungstens.
Order KP507 for LA-9 torches
Order KP508 for LA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel, alu-
minum and copper alloys. See publication C9.10.
10